Fully Automatic computerized system.
80-120 Ton (800 kN -1200 kN)
Compression platens dimensions 500x310x50 mm.
Compression platens Hardness : 55HRC.
Distance piece using to minimize Vertical daylight until 100 mm.
Vertical daylight 300 mm.
Loading speed control.
Pressure relief valve.
Test can be made manually or automatically .
Comes with test software.
Distance pieces should be ordered separately.
220-240 V 1 ph 50 Hz.

Pumice Press is a device used in concrete testing devices and is used to measure the durability of vehicles such as concrete, block brick, block concrete.

It provides reliable and consistent testing of the durability of concrete product samples with a capacity of 800 KN to 1200 KN. These products, which have a special design for test results, are pressure tested and used to determine the behavior of materials under breaking loads.

The deformation results that may occur at various loads by compressing the samples during use are tested, and then these test results are recorded in the system. In fact, when these products are used, it is revealed how much they are resistant to load and how much deformation they will undergo.

During the tests with test devices, the parts that affect the result are the lower and upper pressure plates of the product. Thanks to the fully automatic computerized system, all of these test results can be seen in the computer software and it is possible to use them manually or automatically, as well as digitally save them.

Pumice Press Features

The most basic and functional feature of the pumice press is that it has a fully automatic computerized system. At the same time, the dimensions of the table in the product are 500x310x50 mm and the degree of hardness of the table is 55HRC.

Thanks to these features, it is possible to get the most reliable results in loads between 80 tons and 120 tons. In particular, revealing the results obtained during the pressure test in the closest way to the truth provides security at the points where these products will be used later on. When the correct pressure report is not created, the structures in which concrete or brick products are used cannot withstand the pressure they encounter and break apart. In this case, it causes the buildings to collapse, especially when used in buildings.

If we look at the other features of the product, the speed adjustment allows the pressure given to the products to be increased gradually. Thus, it becomes possible to reach more precise results.

While the plates can be brought closer to each other at a distance of 300 mm, this distance is reduced to 100 mm thanks to the spacer.

Thanks to the test equipment with a hydraulic system with safety valve, the safety of the user during the experiment will thus be ensured.

Pumice Press Usage

It is possible to obtain very easy and reliable results with the Pumice Press, the testing device that enables experienced or inexperienced operators to use it. The device’s easy-to-understand and easy-to-use mechanism enables even people who do not have experience in this field to test easily.

For the use of pumice press, firstly the device must be opened and the sample must be placed in the sample center with the help of the apparatus. All the operations carried out at this time are easily carried out with these devices, which have a simple working order, and the pressure tests applied are very easy because the test parameters can be adjusted and the speed ratio can be included.

Due to the automatic fast run execution indication, this operation only needs to be performed during sample change. However, care must be taken that the sample does not come into contact with the top plate during use. Because if the device that automatically shows the approach touches the plate, the fast approach ends and the next approach and pressure test is carried out slowly.

These devices, which have both manual and automatic use, save similar data to the device, making it possible to use them later without a computer. Test programs are loaded into the devices and the devices are sold and there is no need to reload the program.