Lever Support

LEVER SUPPORT (drill-holder type)

Complete with washers and penetrating rods made of brass, clamps and locking supports

Used to determine the hardening time of products and systems for protecting and repairing concrete structures.

Dimensions: 380 x 300 x 500 mm

Weight: 12 kg

It is possible to get information about the hardening time of the cement within the scope of the data obtained by the workability determination time device. Thus, it makes it easier to have information about how long the cement will harden well and how long it should be used.

It is very important how long the cements used during the construction of the building solidify, and the duration of the operations is determined by taking into account how long it takes people to meet during production. In other words, how much cement to be used in the building should be made and how long this amount should be used is thus determined.

Thanks to this device, which can be used in all cement structures, it is possible to measure at many different points. Construction areas that require fine workmanship, as well as the scope of industry that produces construction materials, produce products according to these data and then sell them.

What are the Technical Elements of Determining the Workability Determination Time?

There are some technical factors that should be considered during the use of the workability determination time device. In particular, the loading arm in this device is easy to use and enables people to carry out the tests they will perform in a more practical way.

In addition, the measurements are carried out in the most sensitive way thanks to the support system prepared vertically and the scales inside. In order to increase the accuracy during the measurement, analyzes are made from many different aspects and it is necessary to reach clear results by comparing the data obtained from these analyzes.

At the same time, thanks to the brass tip supplied to the device, the measurement is completed and the immersion system is applied at the same time with this tip.

Within the scope of following all these steps, the strength degree of the cement mortar is determined, and it is possible to have information about whether the active substance is sufficient and at the same time to comment on the duration.

Having a qualified structure of the sample container also ensures that all these processes in terms of placing and changing the mortar are completed in a short time, and at the same time, it also reveals that it can be carried out easily.

Machinability Determination Time Device Features

The devices in which the materials used in building construction are tested must be produced in accordance with universal standards, and the workability determination time device is produced in accordance with EN 13294 and TS EN 1015-9 standards.

This device, which has a drill type arm, also forms a whole with the penetration bar, compression and locking support. The weight of the product is 12 kg, which makes it easy to transport, and its dimensions of 380 x 300 x 500 mm also allow it to occupy more space in terms of space.

It enables data to be entered in order to reach all measurement units through the digital display located on the front of the product and also to apply the determined criteria during the process. Thus, the results obtained are presented in the most accurate way and the measurements of the products to be used are made in accordance with the standard.