Desiccator

The use of a desiccator is for the protection of materials affected by moisture. The extraction of water from the container samples contained in the desiccant is preferred for a dry wedge of the mine. It is produced from thick glass and aluminum.

In this, chemicals or materials that are affected by external atmospheric conditions are also protected. In this respect, the device has a wide-ranging use. Drying takes approximately 2-3 hours, although it varies according to the product inside.

The lid must be firmly closed for the desiccators to work. Therefore, it should be carefully checked after the material is put into it. Likewise, the desiccator should be closed after the product is taken. The use of desiccator is generally done in laboratories today.

If you are looking for first-class desiccators that you can use for a long time, our company provides you with the best solutions.

Desiccator Models

Today, the desiccator is used for dewatering and dehumidification of different materials. There are different desiccators in this aspect. Because the thickness required for the removal of moisture in each material is different. Being aware of this, our company offers you the following options in this context;

AR-093 Desiccator 210 mm
AR-094 Desiccator 240 mm
AR-095 Desiccator 300 mm
AR-096 Desiccator 210 mm Vacuum
AR-097 Desiccator 240 mm Vacuum
AR-098 Desiccator 300 mm Vacuum

Each of these is designed specifically for use. Therefore, you should examine among the desiccator models and choose the most suitable ones for you. But whichever you choose, our company offers you the best solutions.

Therefore, there are two types, normal and vacuum. Our company offers both of these to you in different sizes. For the continuity of the dry environment without moisture, the desiccant at the bottom should be replaced at certain intervals.

For this purpose, a certain amount of new and fresh desiccant can be added or the used desiccant can be purified from moisture by heating. These products we have presented to you have a suitable structure for both.

What are the Points to Consider in the Use of Desiccator?

The use of the desiccator can be done in a very practical way. The lid must be opened first, and then completely emptied. It is cleaned without damaging it, using water first, then detergent or soap if necessary.

Then it should be dried in a way that it does not remain wet both inside and outside. Anhydrous calcium chloride chemical is discharged into the chamber made for the dryer in the lower part of the desiccator with a paper folded in the shape of a funnel.

In this way, the dryer is placed on the bottom with a thickness of 1 cm. The desiccator cover is closed by placing the porcelain base. A small amount of vaseline is applied for easy opening of the lid.

It is also not recommended to put a very hot pot directly. First of all, it should be cooled outside to 60-70 degrees, then it should be taken into a desiccator. If a very hot item is placed and the cover is closed, the cover may fall and be damaged as the air expands.