This device is used to determine the tensile strength of materials such as lime, gypsum, plaster by sticking them.

Compact lightweight (3.5kg).

The load is given by turning the crank handle.

The reading is read from digital or mechanical manometers.

Various models with different capacities are available.

Adhesion discs are 20 and 50 mm.

The accessories of the tool must be ordered separately.

An electric drill is needed to perform this test.

The Pull Off Tester, which is produced and used to evaluate the shear and tensile strength of construction materials such as plaster, plaster and lime, cement, concrete, is used effectively to measure the adhesion force and tensile strength between two material layers.

This device, which performs the tests required for the repair of a structure where the bond strength between two layers is very important, draws attention as a very light product. It is possible to get the most accurate results with the Pull Off Tester, which is designed and produced to measure the adhesion value of construction materials, paint films or coatings on a surface.

It has all the standards it should have. This device, with which highly reliable and consistent results can be obtained, performs manual testing, and we have models of different capacities for this device. By contacting Argon Test, you can get detailed information about our services and devices and learn the best prices.

Pull Off Tester Features

The Pull Off Tester, as a device that measures the adhesion and tensile strength between two layers of material, is a device used in the repair of any structure where the bond strength between two layers on any surface is important and gives very consistent results. Pull Off Tester features are as follows;

It is a very light, compact and portable device with a weight of 3.5 Kg.
It has a high resolution and very large screen.
It can be produced in quite a variety of models with different capacities.
It can operate in a wide range of test applications.
An electric drill is required for the tests to be carried out with this device.
It has a measuring capacity of 16 kN.
There are two adhesion discs, 20 mm and 50 mm.
Thanks to the rotating hand jack, direct pulling force is applied.
The load on this device is given by turning the crank handle.
Readings are made from mechanical or digital manometers.
The device accessories and apparatus are not included in the shipping of this device, so these accessories must be ordered separately.

How to Use Pull Off Tester?

For the use of the Pull Of Tester, a dolly is first attached to the surface to be tested. Then a cut is made around the dolly so that the film is isolated. With the Pull-Off Tester, which is used with a rotating hand jack and a direct pulling force is applied with this hand jack, the wheel is rotated after the dolly is placed on the tool surface, and then this test is performed with a gradually increasing high pressure force.

Thanks to the electronic display, the force applied at the moment of separation can be seen. It can be used in a very simple and practical way due to its very easy use. You can get detailed information by contacting our company at any time to have the best quality Pull Off Tester with Argon Test quality and assurance.